本文へスキップ

オカノ電機株式会社はカスタムオーダーメイド装置を専門とする会社です。

English中文(簡体)Malay

TEL. 042-471-3316 TOKYO JAPAN

UNIT CHECKER

Service List


○○○○○○○○イメージ

We have produced a function test equipment of the mounting board to meet your custom needs.

・Connector desorption jig
・Screw fastening jig
・Semi-automatic air press
・Heat aging jig
         ets


Product Line

「J TYPE」

  • BOX is the type of fixture. Stage rises from the lower surface by pressing the handle, contact the probe will make the inspection by contacting the substrate.
  • From simple pin stand up to mechanical function system, including the inspection circuit,You can respond to all the needs.
  • Width is 350mm ~ 650mm wide of the lineup and to the casing.
  • It becomes very low cost. (~ Main body portion 36,000)
  • Production in a short delivery time by the standardization of the housing is also possible.
  • Panel processing to the front and rear body, component mounting, also because at the bottom that can be stored in the test circuit and power class by attaching an aluminum BOX (optional), you can build a system of all-in-one.
  • Others, mechanism tailored to your needs, we can design and manufacture of the test circuit.Feel free to contact us, please contact us.
  • PDF


「ZP TYPE」

  • It is pin jig part interchangeable jig.
    Contact probe is brought into contact with the substrate vertically to handle by press, do the inspection.
  • From simple pin stand up to mechanical function system, including the inspection circuit,
    You can respond to all the needs.
  • Because of the possible exchange of jig part in one press, the second and subsequent The new model costs down in the production of only jig part.
  • Variations of the housing size There are five types.
  • Not only the upper and lower operation of using the cylinder, is also popular behavior before and after the substrate set stage to improve workability.
  • High-precision pin stand is possible. (Okano Fine hit probe φ0.3mm pin available.
  • Others, mechanism tailored to your needs, we can design and manufacture of the test circuit.
  • PDF



「Special press type」

  • Automatic, according to the semi-automatic and your needs, and then manufacture the mechanical portion.
  • Not only the upper and lower operation of using the cylinder, is also popular behavior before and after the substrate set stage to improve workability.
  • We also made a jig that does not make a probe, such as a connector desorption jig screw tightening jig.


「Flash ROM write-type」    

Example: writing system to the multifaceted with board

Via the Buffer board, writes of the board with 25 surface.
Sequentially perform the 25-screen portion of writing every five faces in the control side.

We also carried out such as a line system proposal other than the above.


PDF

「Show automatic examination with function tester ESF2003」       

The display automatic inspection with function tester that uses a CCD camera. LCD, corresponding LED variety of display patterns to identify possible CAN ・ LIN ・ 232C, such as a variety of communication standards. Ideal for traceability management using bar code.
PDF


バナースペース

OKANO ELECTRIC CO,.LTD.

〒203-0003
2-8-18 KANAYAMA-CHO HIGASHIKURUME TOKYO JAPAN

TEL +81-42-471-3316
FAX +81-42-474-1675